Description

Speedometer

High speed recall
0-60 MPH time
1/4 mile elapsed time recall
Reads up to 255 MPH
Odometer and trip meter
Calibrate to adjust for different tire sizes, wheel sizes, and gear ratios
Electronic GM speedometer sender included

Tachometer

Microprocessor controlled with peak rpm memory recall
0-9999 readout in 1, 10 or 100 RPM increments (ex. 9,900 , 9,990 , 9,999)
Works on 1-2-4-6-8-10-12 cylinder engines
Programmable red line (full bars is set at default of 6500 RPM)

*If using with an LS engine you may also need the Intellitronix LS swap kit (8014LS)

Fuel

reads in percentage (empty-full) 0-100% range in 1% increments
Ohm ranges include:
- GM 0 – 30 ohm
- GM 0 – 90 ohm
- Universal 240 – 33 ohm
- GM 40 – 250 ohms

Voltmeter

Reads in .1 volt increments from 7.0 to 16.0 volts
No sender needed

Oil Pressure

Reads in 1 PSI increments from 00 to 99 PSI
Comes with S8868 oil pressure sender

Water Temperature

10-355 Fahrenheit degree accuracy.
Sending unit included

BEZEL NOT INCLUDED

Additional features:

High Beam Indicator
Check Engine Light
Brake Indicator
Turn Signals
Night time dimming

Optional add ons:

GPS Speedometer Sending Unit (S9020): Accurate readings with a simple 3-wire hookup. Works with 4000, 8000, or 16000 PPM speedometers. Use to bypass vehicle transmission or computer, picks up speed from satellite signal

Universal Gauge Harness (QCWH20): 8′ harness includes color-coded wires, quick-connects for easy removal, and all hardware needed for gauge wiring. Please note this does not plug into the factory harness

LS Swap Kit (8014LS): Required for GM LS engines, includes 12mm & 16mm bushings and a 10K-1/2 watt resistor to boost tach signal